RideForum.NET

Has anyone had the problem of their GPS truncating routes? My Etrex Legend w/ Mapsource Road and Rec software has begun truncating routes. I checked my route waypoint numbers and GPS memory and both are within limits. Truncate = route is cut off. Thanks for any help with this.

Routes have a limit to the number of points in each route, as well as the total number of points in all routes combined.

I believe for my 60CS (not x), the limit per route is 500. Check Garmin.com for your specific GPS.

My work around was to split the route into parts. I ran into this issue when planning my CO-2006 trip. The GPS will flash a short message during upload that the route is truncated, but MapSource will not tell you. Nor will MS allow you to limit the number of trackpoints, OR set it automatically based on the GPS ID already in the program.

From: http://www.garmin.com/products/etrexLegend/

I did a "comparison", choosing just the etrex legend (from the page above):

eTrex Legend
Receiver 12 channel
Number of Waypoints 1,000
Built in Memory 8 MB
# of Routes / # of waypoints per route 20/125
Database, Basemap, or Built-in Maps Americas Highway or
Atlantic Highway or
Pacific Highwayand Marine Point Database
Additional map options MapSource CD-ROM uploadable information
Battery Life 18 HR (2 AA)
Display Size 2.1 x 1.1
Display Type 4 level Gray LCD
Area Calculation Yes
Display Resolution 288 x 160
Standard GPS Antenna Built in
TracBack Mode Yes
# of Tracklog Points 10,000
Unit Weight 5.3 oz.
Audible Alarms No
Waterproof Standard IPX7
Unit Dimensions 2.0" W x 4.4" H x 1.2" D
Thumb Stick (5-position cursor switch) Yes
Map Storage Internal Memory
Backlit Display Single level
Ext. Ant. Hookup N/A
WAAS/EGNOS capability Yes
Loran TD position format Yes
MGRS position format Yes
Hunting/Fishing calculator Yes
Celestial Information Page Yes
Proximity Waypoints N/A
Built in calendar Yes
Voltage Range 2.5
Waypoint Icons Yes
MSRP $160.70

Thanks for the info Mike. I have been pulling my hair out for over a week. I'll try breaking my routes into smaller sections and see if it works. I think I was averaging 150 route points when the limit is 125 for a Etrex legend.

To see how many points are in a route:

Open MapSource.
Double click on the route in the left hand navigation bar.
Choose the "Directions" tab in the Route Properties box that opens.

To split a route (there may be a better way ... )
Right click on the route that is too long.
Choose Duplicate Route
Edit both routes so that they each have under your point limit by deleting from the start or the end.

Thanks, the routes worked out fine once I separated into two routes. Hope to limp the Etrex Legend through another year until I can pick up a color unit. Isn't it great having a forum like this to get some help. Kudos to Troy for keeping this group going.

MacWildcat wrote:Thanks, the routes worked out fine once I separated into two routes. Hope to limp the Etrex Legend through another year until I can pick up a color unit. Isn't it great having a forum like this to get some help. Kudos to Troy for keeping this group going.

Thanks, Mac! You are definitely part of the success. Thanks for your help.